Transmission Fluid Temperature Sensor Inspection; O/D Off" Switch Inspection - Suzuki Liana RH413 Service Manual

5A-86 Automatic Transmission/Transaxle:
Installation
Reverse removal procedure to install solenoid wire
harness and valve body assembly noting the following
points.
• For details of valve body assembly and their
connectors installation, refer to "Automatic Transaxle
Unit Assembly".
• For details of A/T oil pan installation, refer to
"Automatic Transaxle Unit Assembly". Use new oil
pan gasket.
• Tighten valve body harness connector bolt to
specified torque.
Tightening torque
Valve body harness connector bolt (a): 5.5 N·m (
0.55 kgf-m, 4.0 lb-ft)
• Pour A/T fluid and check fluid level according to
procedure described in "A/T Fluid Change".
• Check for fluid leakage after warning up A/T.
Transmission Fluid Temperature Sensor
Inspection
Warm up transmission fluid temperature sensor (2).
Check resistance between terminals of valve body
harness connector (1). Thus make sure its resistance
decrease as its temperature increase.
Transmission fluid temperature sensor resistance
10 °C (50 °F): 5.8 – 7.1 kΩ
110 °C (230 °F): 231 – 263 Ω
145 °C (293 °F): 105 – 117 Ω

"O/D OFF" Switch Inspection

I2RH0B510051-01
1) Remove console box.
2) Disconnect O/D off switch connector (1).
3) Check continuity between O/D off switch terminals.
"O/D OFF" switch specification
With O/D off switch under being pressed (3):
Continuity
S3RH0A5106013
With O/D off switch under being released (2): No
continuity
1
2 3
I3RH0A510035-01
S3RH0A5106014
I4JA01512016-01