Suzuki Liana RH413 Service Manual page 697

45) After applying A/T fluid to reverse clutch drum thrust
bearing (1), install it to forward and reverse clutch
assembly (2).
46) Remove sealant attached to mating surface of
transaxle rear cover (1) completely.
47) Apply sealant to mating surface of transaxle rear
cover (1) by using a nozzle (2) as shown in figure by
such amount that its section is 1.2 mm (0.047 in.) in
diameter.
"A": Sealant 99000–31230
"A"
48) Install transaxle rear cover assembly on transaxle
case.
49) Tighten rear cover bolts (1).
Tightening torque
Rear cover bolt (a): 25 N·m (2.5 kgf-m, 18.0 lb-ft)
50) Install transaxle hook (2) to location shown in figure
and tighten nut (3).
Tightening torque
Transaxle hook nut (b): 18 N·m (1.8 kgf-m, 13.0
lb-ft)
I2RH0B510300-01
51) Install fluid reservoir LH plate (1).
2
1
I2RH0B510301-01
52) After applying A/T fluid to new governor apply No.2
53) After applying A/T fluid to differential assembly (1)
Automatic Transmission/Transaxle:
Tightening torque
Fluid reservoir LH plate bolt (a): 10 N·m (1.0 kgf-
m, 7.5 lb-ft)
gasket (1), install it to transaxle case.
and countershaft assembly (2), install them to
transaxle case.
5A-149
I2RH0B510302-01
I2RH0B510303-01
I2RH0B510304-01