Transfer Output Retainer Assembly Disassembly And Assembly - Suzuki Liana RH413 Service Manual

3C-11 Transfer:
5) Install oil protect plate (1) and oil receiver (2) to right
case (3).
Tightening torque
Oil protect plate bolts (a): 12 N·m (1.2 kgf-m, 9.0
lb-ft)
Oil receiver bolt (b): 12 N·m (1.2 kgf-m, 9.0 lb-ft)
1
(a)
6) Apply grease to reduction drive gear oil seal lips.
"A": Grease 99000–25010
7) Install reduction drive gear oil seals (1) to left case
(2) by using special tool.
CAUTION
!
Use care of the installation direction and
depth of oil seals for correct installation.
Special tool
: 09913–85210
Transfer reduction drive gear oil seal installing
depth
"a": 13.0 – 14.0 mm (0.512 – 0.551 in.)
"b": 2.5 – 3.5 mm (0.098 – 0.138 in.)
8) Screw bevel gear adjuster (1) in left case (2) until
side face of bevel gear adjuster (1) come to flush
position with side face of left case (2) by using
special tool.
(b)
2
(a)
3
I3RH01332032-01
I3RH01332033-01
Special tool
(A): 09940–14940
NOTE
Do not screw in bevel gear adjuster
excessively, or preload of reduction idler
gear taper roller bearing may not be adjusted
accurately.
(A)
Transfer Output Retainer Assembly
Disassembly and Assembly
Disassembly
1) Uncaulk transfer output flange nut.
2) Remove transfer output flange nut while holding
flange (1) by using special tool.
Special tool
(A): 09930–40113
(A)
3) Remove transfer output flange (1) by bearing puller
(2).
1
2
I3RH01332034-01
S3RH0A3306007
1
I3RH01332017-01
2
1
I3RH01332018-01