Gear Shift Control Lever And Cable Removal And Installation; Vehicle Speed Sensor (Vss) Removal And Installation - Suzuki Liana RH413 Service Manual

5B-9 Manual Transmission/Transaxle:
Gear Shift Control Lever and Cable Removal
and Installation
Removal
1) Remove console box.
2) Disconnect gear shift control cables from gear shift
control lever assembly.
3) Remove gear shift control cable guide nuts and gear
shift lever assembly from body.
4) Disconnect gear shift control cables from transaxle.
5) Remove E-rings, cable grommet and cable clamp,
and then remove gear shift control cables from body.
Installation
Reverse removal procedure for installation and note as
follows.
• Tighten each bolts and nuts to specified torque
referring to "Gear Shift Control Lever and Cable
Components".
• Apply grease to turning or sliding portions.
: Grease 99000–25010
Vehicle Speed Sensor (VSS) Removal and
Installation
Removal
1) Disconnect negative cable at battery.
2) Disconnect VSS coupler (1).
3) Remove VSS (2).
2
Installation
1) Apply oil to new O-ring (1) and then install VSS to
S3RH0A5206004
2) Connect VSS coupler (1).
S3RH0A5206005
3) Connect negative cable at battery.
1
I4RH01520005-01
transaxle.
Tightening torque
VSS bolt (a): 5.5 N·m (0.55 kgf-m, 4.0 lb-ft)
I2RH01520018-01
1
I2RH01520016-01