Differential Assembly Disassembly And Reassembly - Suzuki Liana RH413 Service Manual

Differential Assembly Disassembly and
Reassembly
Disassembly
1) Remove final gear bolts (1), and then final gear (2).
2) Remove differential side RH bearing by using special
tools.
Special tool
(A): 09926–37610
(B): 09926–37610–001
(C): 09926–37610–003
(D): 09926–37610–002
3) Remove output shaft speed sensor / VSS drive gear
(1).
2. Differential case subassembly
4) Remove differential side LH bearing by using special
tools.
S3RH0A5106053
Special tool
(A): 09926–37610
(B): 09926–37610–001
(C): 09926–37610–003
(D): 09926–37610–002
I2RH0B510225-01
Reassembly
WARNING
!
• When taking warmed final driven gear out
of vessel, use tongs or the like. Taking out
it with bare hand will cause severe burn.
• While installing warmed final driven gear,
use oven glove such as leather glove.
Picking up it with bare hand may cause
burn.
CAUTION
!
Do not leave final driven gear in boiling water
for longer than 5 min. Overheating the gear
I2RH0B510226-01
may cause strength reduction of gear.
1) Put final driven gear in water vessel, heat and
remove when it boils, then remove moisture.
NOTE
After removing moisture on final driven gear,
install final driven gear to differential case as
quickly as possible.
I2RH0B510227-01
Automatic Transmission/Transaxle: 5A-133
I2RH0B510228-01
I2RH0B510229-01