Spark Plug Removal And Installation; Spark Plug Inspection; Ignition Coil Assembly (Including Igniter) Removal And Installation - Suzuki Liana RH413 Service Manual

Spark Plug Removal and Installation

Removal
1) Remove engine cover from cylinder head cover
referring to Step 3) of "Removal" under "Cylinder
Head Cover Removal and Installation in Section 1D".
2) Pull out high-tension cords by gripping their caps
and then remove ignition coil assemblies referring to
"Ignition Coil Assembly (Including Igniter) Removal
and Installation".
3) Remove spark plugs.
Installation
1) Install spark plugs and tighten them to specified
torque.
Tightening torque
Spark plug: 25 N·m (2.5 kgf-m, 18.0 lb-ft)
2) Install ignition coil assemblies referring to "Ignition
Coil Assembly (Including Igniter) Removal and
Installation".
3) Install high-tension cords securely by gripping their
caps.
4) Install engine cover to cylinder head cover referring
to Step 11) of "Installation" under "Cylinder Head
Cover Removal and Installation in Section 1D".

Spark Plug Inspection

CAUTION
!
• When service the iridium / platinum spark
plugs (slender center electrode type
plugs), do not touch the center electrode
to avoid damage to it. The electrode is not
strong enough against mechanical force
as it is slender and its material is not
mechanically tough.
• Do not clean or adjust gap for the iridium /
platinum spark plugs.
• Electrode wear
• Carbon deposits
• Insulator damage
If any abnormality is found for nickel spark plugs, adjust
air gap, clean with spark plug cleaner or replace them
with specified new plugs.
For iridium / platinum spark plugs, replace them with
new plugs.
Spark plug air gap
"a": 1.0 – 1.1 mm (0.040 – 0.043 in.)
Spark plug type
NGK: BKR6E-11 (Nickel) / IFR6E11 (Iridium) / IFR6J11
(Iridium)
DENSO: K20PR-U11 (Nickel)
NOTE
S3RH0A1806001
NGK IFR6E11 / IFR6J11 is highly
recommended for better engine starting
performance under –25 °C (–13 °F).
Ignition Coil Assembly (Including Igniter)
Removal and Installation
Removal
1) Disconnect negative cable at battery.
2) Remove engine cover from cylinder head cover
referring to Step 3) of "Removal" under "Cylinder
Head Cover Removal and Installation in Section 1D".
3) Disconnect ignition coil coupler.
S3RH0A1806002
4) Disconnect high-tension cord (3) from ignition coil
assembly (2) while gripping its cap.
5) Remove ignition coil bolts (1) and then pull out
ignition coil assembly.
Installation
1) Install ignition coil assembly.
2) Tighten ignition coil bolts, and then connect ignition
coil coupler.
3) Install high-tension cord to ignition coil assembly
while gripping its cap.
4) Install engine cover to cylinder head cover referring
to Step 11) of "Installation" under "Cylinder Head
Cover Removal and Installation in Section 1D".
5) Connect negative cable to battery.
Ignition System: 1H-7
IYSQ01181012-01
S3RH0A1806003
I2RH0B180006-01