Suzuki Liana RH413 Service Manual page 804

6C-13 Power Assisted Steering System:
iv) Remove engine rear mounting nuts (2), and
then remove suspension frame (4) from
body.
v) Remove right (5) and left (6) transfer stiffener
and remove transfer mounting bolts, and
then draw out transfer assembly (3) from
transaxle.
Installation
Reverse removal procedure for installation of steering gear box noting the following points.
CAUTION
!
Be sure to confirm that steering wheel and front tires (wheels) are in straight position when inserting
steering lower joint into steering pinion shaft.
• Use specified torque as follows.
Tightening torque
Gear box mounting bolt (a): 55 N·m (5.5 kgf-m, 40.0 lb-ft)
Gear box cylinder pipe flare nut (b): 25 N·m (2.5 kgf-m, 18.0 lb-ft)
Gear box high and low pressure pipe flare nut (c): 35 N·m (3.5 kgf-m, 25.0 lb-ft)
Tie-rod end castle nut (d): 45 N·m (4.5 kgf-m, 32.5 lb-ft)
Steering shaft upper and lower joint bolt (e): 25 N·m (2.5 kgf-m, 18.0 lb-ft)
8) Remove cylinder pipes (3) and (4) from steering gear
box using flare nut wrench.
NOTE
As fluid flows out of disconnected joints, put
a receptacle under joints or a plug to pipe.
9) Disconnect high pressure pipe (1) and low pressure
hose (2) from steering gear box using flare nut
wrench.
NOTE
As fluid flows out of disconnected joints,
have a receptacle under joints or a plug to
pipe.
10) Remove steering gear box mounting bolts, and then
remove steering gear box from vehicle.
I2RH0B630008-01
I2RH0B630009-01
I2RH01630029-01