A/T Fluid Cooler Hoses Replacement - Suzuki Liana RH413 Service Manual

Installation
1) Lay interlock cable to its original cabling route.
2) Turn ignition switch to ACC position.
3) Insert cable casing cap (1) into key cylinder cover (2)
securely.
2
4) Pull out lock button (1) of selector side cable end (2).
5) Shift selector lever to "N" position.
NOTE
If selector lever is in "P" position, shift
selector lever referring to "Selector Lever
Inspection".
1
I2RH01510085-01
2
1
1
I2RH01510086-01
Automatic Transmission/Transaxle:
6) Install cable casing cap (3) to selector bracket (4).
7) Connect cable end (1) to interlock cam (2) with
ignition switch turned to ACC position.
8) Drive lock button (5) in cable end until it locks cable
expansion and contraction.
2
1
9) With selector lever set at "P" position, turn ignition
key to ACC position and then check for the following
conditions.
• With knob button released, ignition key can be
turned from ACC position to LOCK position.
• With knob button pressed, ignition key cannot be
turned from ACC position to LOCK position.
10) Install steering column cover.
11) If the vehicle is equipped with air bag system,
connect negative cable at battery and enable air bag
system, referring to "Enabling Air Bag System in
Section 8B".

A/T Fluid Cooler Hoses Replacement

The rubber hoses for the A/T fluid cooler should be
checked at specified interval. If replacing them, be sure
to note the following.
• to replace clamps at the same time
• to insert hose as far as its limit mark
• to clamp clamps securely
2
1
1. Radiator
2. Inlet hose (Outlet from A/T fluid cooler)
3. Outlet hose (Inlet to A/T fluid cooler)
5A-95
3
5
3
4
I2RH01510087-01
S3RH0A5106022
3
I2RH0B510069-01