Manual Transaxle Assembly Disassembly And Assembly - Suzuki Liana RH413 Service Manual

5B-19 Manual Transmission/Transaxle:
7) Fit 5th gear shift fork (1) to sleeve (3) and hub (2)
assembly, and install them into input shaft and gear
shift shaft, aligning punch mark (4) with matching
mark (5) on input shaft.
8) Tighten shift fork shaft bolt (2) to which thread lock
cement has been applied.
"A": Thread lock cement 99000–32110
Tightening torque
Shift fork shaft bolt (a): 10 N·m (1.0 kgf-m, 7.5 lb-
ft)
9) Using special tool, install new circlip (1) to input shaft
(3) in specified direction as shown in figure.
Special tool
: 09900–06107
3
2, (a), "A"
1
4. Polished surface
10) Clean mating surface of both left case (2) and side
I3RH0A520080-01
Manual Transaxle Assembly Disassembly and
Assembly
Disassembly
3
4
1
I4RH01520051-01
cover (1), apply sealant to side cover as shown in
figure by such amount that its section is 1.5 mm
(0.059 in.) in diameter, mate it with left case, and
then tighten side cover bolts with specified torque.
"B": Sealant 99000–31260
Tightening torque
Side cover bolt (a): 10 N·m (1.0 kgf-m, 7.5 lb-ft)
1) Remove left case plate bolts (1), and take off left
case plate (2).
3. Input shaft
I3RH0A520081-01
S3RH0A5206015
I4RH01520018-01