Rear Wiper And Washer Switch Inspection; Rear Wiper Intermittent Relay Removal And Installation; Rear Wiper Intermittent Relay Inspection - Suzuki Liana RH413 Service Manual

9D-7 Wipers / Washers:

Rear Wiper and Washer Switch Inspection

Check for continuity between terminals at each switch position. If check result is not as specified, replace switch.
Rear Wiper Intermittent Relay Removal and
Installation
Removal
1) Disconnect negative (–) cable from battery.
2) Remove rear side still scuff (1), rear luggage end
garnish (2) and quarter inner trim (3).
3) Remove rear wiper intermittent relay (1) from
vehicle.
[A]: LH steering vehicle
[B]: RH steering vehicle
S3RH0A9406010
3
1
2
I3RH0A940006-01
Installation
Reverse removal procedure.

Rear Wiper Intermittent Relay Inspection

1) Check INT circuit as follows.
a) Connect battery positive (+) terminal to "h"
terminal and battery negative (–) terminal to "e"
terminal.
b) Check that voltage between "b" terminal and "e"
terminal changes from 0 V to battery voltage
when connecting battery positive (+) terminal to
"g" terminal.
If check result is not satisfied, replace relay.
S3RH0A9406009
I3RH0A940005-01
1
I3RH0A940007-01
S3RH0A9406011