Suzuki Liana RH413 Service Manual page 670

5A-122 Automatic Transmission/Transaxle:
5) Remove forward clutch return spring subassembly
(1).
2. Intermediate shaft subassembly
6) Install intermediate shaft subassembly (1) to
transaxle rear cover (2). Apply compressed air (400
– 800 kPa, 4 – 8 kg/cm
of transaxle rear cover to remove forward clutch
piston (4).
7) Apply compressed air (400 – 800 kPa, 4 – 8 kg/cm
57 – 113 psi) to oil hole (1) of transaxle rear cover to
remove forward clutch drum (2).
I2RH0B510181-01
2 , 57 – 113 psi) to oil hole (3)
I2RH0B510182-01
I2RH0B510183-01
8) Remove forward clutch piston O-ring (1) from
intermediate shaft subassembly (2).
9) Remove forward clutch drum O-ring (1) from forward
clutch drum (2).
10) Remove intermediate shaft seal ring (1) from
intermediate shaft subassembly (2).
2 ,
Reassembly
Reverse disassembly procedure for assembly, noting the
following points.
• Before assembling, apply automatic transaxle fluid to
component parts.
• Replace O-rings and seal ring with new ones.
• Do not damage forward clutch subassembly and
balancer (1) by pressing forward clutch return spring
subassembly passing through its original installing
position over 1.5 mm (0.059 in.).
Special tool
(A): 09926–97610
I2RH0B510184-01
I2RH0B510185-01
I2RH0B510186-01