Abs Warning Lamp Comes On Steady - Suzuki Liana RH413 Service Manual

4E-16 ABS:
Troubleshooting
Step
1 1) Turn ignition switch to ON position.
Do other warning lamps come ON?
2 1) Turn OFF ignition switch.
2) Disconnect ABS hydraulic unit / control module
connector.
3) Turn ON ignition switch.
Does ABS warning lamp light with ignition switch ON?
3 1) Remove combination meter with ignition switch turned
OFF.
2) Measure resistance between "RED/WHT" wire of
combination meter connector and ground.
∞
Is it infinite ( )?
4 Is "METER" fuse in good condition?
5 1) Remove combination meter with ignition switch turned
OFF.
2) Check for proper connection to "BLK/RED" wire of
combination meter connector.
3) If OK, turn ON ignition switch and measure voltage at
"BLK/RED" wire of combination meter connector.
Is it 10 – 14 V?
6 1) Measure resistance between "BLK" wire of combination
meter connector and ground.
Is resistance below 5

ABS Warning Lamp Comes ON Steady

Wiring Diagram
[A]: ABS hydraulic unit / control module connector E15
1. Battery
2. Main fuse box
3. Ignition switch
4. Circuit fuse box
Action
Ω
?
5. Combination meter
6. EBD warning lamp (Brake warning lamp)
7. ABS warning lamp
8. Lamp driver module
9. Brake fluid level switch
Yes
Go to Step 2.
Replace ABS hydraulic
unit / control module
assembly.
Go to Step 6.
Go to Step 5.
Go to Step 6.
Replace combination
meter.
10. Parking brake switch
11. ABS hydraulic unit / control module assembly
12. "ABS" fuse (60 A)
13. "ABS" fuse (10 A)
14. "METER" fuse
No
Go to Step 4.
Go to Step 3.
"RED/WHT" circuit
shorted to ground.
Replace fuse and check
for short circuit to
ground.
"BLK/RED" circuit open.
"BLK" circuit open or
high resistance.
S3RH0A4504009
I3RH0A450004-01