Automatic Transaxle Unit Inspection And Adjustment - Suzuki Liana RH413 Service Manual

5A-138 Automatic Transmission/Transaxle:
4) Apply grease to oil seal lip.
: Grease 99000–25030
Automatic Transaxle Unit Inspection and
Adjustment
Inspection
Brake discs
Dry and inspect them for pitting, burn flaking, significant
wear, glazing, cracking, charring and chips or metal
particles imbedded in lining.
If discs show any of the above conditions, replacement
is required.
NOTE
• If disc lining is exfoliated or discolored,
replace all discs.
• Before assembling new discs, soak them
in A/T fluid for at least two hours.
Brake separator plates and retaining plates
Dry plates and check for discoloration. If plate surface is
smooth and even color smear is indicated, plate should
be reused. If severe heat spot discoloration or surface
scuffing is indicated, plate must be replaced.
Brake return spring subassembly
Measure brake return springs.
Evidence of extreme heat or burning in the area of clutch
may have caused springs to take heat set and would
require their replacement.
Free length of 1st & reverse brake return spring
"a": 21.71 mm (0.855 in.)
Free length of 2nd brake return spring
"a": 15.85 mm (0.624 in.)
I2RH0B510252-01
NOTE
• Do not apply excessive force when
S3RH0A5106063
measuring spring free length.
• Perform measurement at several points.
One-way clutch No.1 assembly
1) Install one-way clutch No.1 assembly (2) to rear
planetary sun gear subassembly (1).
2) Securing rear planetary sun gear subassembly,
ensure that one-way clutch No.1 assembly rotates
only in one direction.
If the one-way clutch rotates in both directions or it
does not rotate in either direction, replace it with new
one.
I2RH01510147-01
I2RH0B510253-01
I2RH0B510173-01
I2RH0B510254-01