Automatic Transaxle Unit Dismounting And Remounting - Suzuki Liana RH413 Service Manual

Automatic Transaxle Unit Dismounting and
Remounting
CAUTION
!
When transaxle have been replaced, all
learned contents, which have been stored in
TCM memory by executing learning control,
should be initialized referring to "Learning
Control Initialization".
Neglecting this initialization may cause
excessive shift shock.
Dismounting
1) Disconnect negative cable at battery and transaxle.
2) Disconnect connector for valve body harness,
transmission range sensor, input shaft speed sensor
and output shaft speed sensor / VSS.
3) Undo wiring harness clamps.
4) Disconnect select cable from transaxle.
5) Remove water intake pipe bolts.
6) Remove transaxle and engine fastening bolts.
7) Remove starting motor.
8) Support engine to prevent it from being declined
excessively at removal of mountings.
9) Check around transaxle for any other parts required
to be removed or disconnected for dismounting of
transaxle and remove or disconnect whatever
necessary.
10) Drain automatic transaxle fluid.
11) Remove engine under covers.
12) Disconnect fluid cooler hoses.
13) For 2WD model, remove mounting member.
14) Remove exhaust No.1 pipe (1).
S3RH0A5106024
15) Remove lower stiffener (2).
Automatic Transmission/Transaxle:
1
[A]: 4WD model
[B]: 2WD model
5A-97
I2RH0B510071-01
2
2
I2RH0B510072-01