Suzuki Liana RH413 Service Manual page 653

21) Remove harness bracket (2) and torque converter
housing bolts.
22) Remove torque converter housing (1) while tapping
around it lightly with plastic hammer.
23) Remove breather hose (1).
24) Remove breather union (2).
25) Measure input shaft thrust play.
Apply dial gauge onto input shaft end (1) and
measure thrust play of input shaft.
When input shaft thrust play is out of specification,
select input shaft front thrust bearing with proper
thickness from among the list below and replace it.
Special tool
(A): 09900–20607
(B): 09900-20701
Input shaft thrust play
0.3 – 0.9 mm (0.012 – 0.035 in.)
I2RH0B510095-01
I2RH0B510096-01
1
2
I2RH0B510097-01
Automatic Transmission/Transaxle:
Available input shaft front thrust bearing
thickness
"a": 0.8, 1.4 mm (0.032, 0.055 in.)
26) Remove oil pump assembly (1).
27) Remove direct clutch assembly (1).
28) Remove input shaft front thrust bearing (1).
NOTE
If input shaft front thrust bearing is not
found, it may have been taken out with oil
pump assembly.
5A-105
I3RH0A510028-01
I2RH0B510099-01
I2RH0B510100-01
I2RH0B510101-01