Front Wheel Speed Sensor Ring Removal And Installation; Rear Wheel Speed Sensor Ring On-Vehicle Inspection; Rear Wheel Speed Sensor Ring Removal And Installation - Suzuki Liana RH413 Service Manual

Front Wheel Speed Sensor Ring Removal and
Installation
NOTE
The front wheel sensor ring can not be
removed or replaced alone. If front wheel
sensor ring needs to be replaced, replace it
as a wheel side joint assembly of drive shaft.
For removal and installation of wheel side joint assembly
of drive shaft, referring to "Front Drive Shaft
Disassembly and Assembly in Section 3A".
Rear Wheel Speed Sensor Ring On-Vehicle
Inspection
• Check ring serration (teeth) for being missing,
damaged or deformed.
• Turn wheel and check if ring rotation is free from
eccentricity and looseness.
• Check that no foreign material is attached.
If any faulty is found, repair or replace.
[A]
[B]
[A]: For 2WD vehicle
[B]: For 4WD vehicle
Rear Wheel Speed Sensor Ring Removal and
Installation
S3RH0A4506012
NOTE
The rear wheel sensor ring can not be
removed or replaced alone. If rear wheel
sensor ring needs to be replaced, replace it
as a wheel hub assembly for 2WD vehicle or
wheel side joint assembly of drive shaft for
4WD vehicle.
For removal and installation of wheel hub assembly or
wheel side joint assembly of drive shaft, refer to "Wheel
Hub with Wheel Bearing and Wheel Stud Removal and
Installation (2WD Model) in Section 2C" or "Rear Drive
Shaft Disassembly and Assembly in Section 3A".
S3RH0A4506013
I3RH0A450026-01
ABS: 4E-41
S3RH0A4506014