4D-3 Parking Brake:
Installation
Install it by reversing removal procedure, noting the
following points.
• Install clamps properly referring to "Parking Brake
Cable Construction".
• Tighten bolts and nuts to specified torque referring to
"Parking Brake Cable Construction".
Tightening Torque Specifications
Fastening part
Parking brake lever bolt
Parking brake cable clamp bolt
NOTE
The specified tightening torque is also described in the following.
"Parking Brake Cable Construction"
Reference:
For the tightening torque of fastener not specified in this section, refer to "Fasteners Information in Section 0A".
Tightening torque
Parking brake lever bolt: 23 N·m (2.3 kgf-m, 17.0
lb-ft)
Parking brake cable clamp bolt: 11 N·m (1.1 kgf-
m, 8.0 lb-ft)
• Adjust parking brake cable. Refer to "Parking Brake
Inspection and Adjustment".
• Check brake drum for dragging and brake system for
proper performance. After removing vehicle from
hoist, brake test should be performed.
Specifications
Tightening torque
N⋅m
kgf-m
23
2.3
11
1.1
S3RH0A4407001
Note
lb-ft
17.0
8.0