Combination Meter Removal And Installation; Fuel Level Sensor Removal And Installation; Fuel Level Sensor Inspection - Suzuki Liana RH413 Service Manual

9C-11 Instrumentation / Driver Info. / Horn:

Combination Meter Removal and Installation

Removal
1) Disconnect negative (–) cable at battery.
2) Remove combination meter cluster panel.
3) Remove screws fastening combination meter.
4) Remove combination meter.
Installation
Reverse removal procedure.

Fuel Level Sensor Removal and Installation

Removal
Remove fuel pump assembly referring to "Fuel Pump Assembly Removal and Installation in Section 1G".
Installation
Install fuel pump assembly referring to "Fuel Pump Assembly Removal and Installation in Section 1G".

Fuel Level Sensor Inspection

• Check that resistance between terminals "a" and "b" of fuel level sensor changes with change of float position.
• Check resistance between terminals "a" and "b" at each float position in the following.
If the measured value is out of specification, replace fuel pump.
Fuel level sensor specifications
Float Position
Full Upper "c" 25.3 mm (1.00 in.)
Full Lower "d" 191.2 mm (7.53 in.)
NOTE
• Confirm that fuel meter is in good condition before referring to the following possible causes.
• The low fuel warning light comes ON when the vehicle is in the following insufficient fuel level.
Low fuel warning light operation:
Low fuel warning light operation
OFF
ON
Resistance (Ω)
10 ± 1
130 ± 1
"b"
"a"
1. Fuel pump
2. Float
Fuel level in fuel tank
Approx. 8.5 liter (2.25 gal/US) or more
Approx. 0 – 7.5 liter (0 - 1.98 gal/US)
1
"c"
"d"
2
2
I4RH01930003-01
Fuel level sensor resistance
Approx. 10 – 110 Ω
Approx. 112 – 130 Ω
S3RH0A9306003
S3RH0A9306004
S3RH0A9306005