Suzuki Liana RH413 Service Manual page 731

7) Tighten case bolts (3) from outside to specified
torque.
Tightening torque
Transaxle case bolt (b): 23 N·m (2.3 kgf-m, 17.0
lb-ft)
8) Install reverse shaft bolt (4), to which thread lock
cement has been applied, with aluminum washer
and tighten it.
"A": Thread lock cement 99000–32110
Tightening torque
Reverse shaft bolt (c): 23 N·m (2.3 kgf-m, 17.0
lb-ft)
9) Install another case bolts from clutch housing side
and tighten them to specification.
Tightening torque
Transaxle case bolt: 23 N·m (2.3 kgf-m, 17.0 lb-
ft)
10) Install side bearing retainer as follows (for 2WD).
a) Install differential side bearing outer race to left
case, and tap and accustom outer race using
special tool and plastic hammer.
CAUTION
!
Do not drive in a race with hammer. Driving it
way cause to damage bearing.
Special tool
(A): 09926–27610
b) Select a shim of differential side bearing as
I3RH0A520015-01
Clearance "a" – "b"
0.636 – 0.665 mm
(0.0250 – 0.0261 in.)
0.666 – 0.695 mm
(0.0262 – 0.0273 in.)
0.696 – 0.725 mm
(0.0274 – 0.0285 in.)
0.726 – 0.755 mm
(0.0286 – 0.0297 in.)
0.756 – 0.785 mm
(0.0298 – 0.0309 in.)
0.786 – 0.815 mm
(A)
(0.0310 – 0.0320 in.)
0.816 – 0.845 mm
(0.0321 – 0.0332 in.)
0.846 – 0.875 mm
(0.0333 – 0.0344 in.)
0.876 – 0.905 mm
(0.0345 – 0.0356 in.)
0.906 – 0.935 mm
(0.0357 – 0.0368 in.)
0.936 – 0.965 mm
I4RH01520053-01
(0.0369 – 0.0379 in.)
0.966 – 0.995 mm
(0.0380 – 0.0391 in.)
Manual Transmission/Transaxle:
follows.
i) Measure depth "a" from left case end face (1)
to side bearing outer race (2) using depth
gauge.
ii) Measure height "b" of side bearing retainer
with depth gauge.
iii) Calculate clearance "a" – "b", and select a
shim according to the following table.
Bearing shim
Thickness of bearing shim to
0.75 mm (0.030 in.)
0.78 mm (0.031 in.)
0.81 mm (0.032 in.)
0.84 mm (0.033 in.)
0.87 mm (0.034 in.)
0.90 mm (0.035 in.)
0.93 mm (0.037 in.)
0.96 mm (0.038 in.)
0.99 mm (0.039 in.)
1.02 mm (0.040 in.)
1.05 mm (0.041 in.)
1.08 mm (0.043 in.)
5B-22
I3RH0A520079-01
b
I4RH01520045-01
be installed