Passenger Air Bag (Inflator) Module Removal And Installation - Suzuki Liana RH413 Service Manual

8B-103 Air Bag System:
Passenger Air Bag (Inflator) Module Removal
and Installation
WARNING
!
• Never attempt to disassemble or repair the
passenger air bag (inflator) module. If any
abnormality is found, be sure to replace it
with new one as an assembly.
• Be sure to read "Precautions on Service
and Diagnosis of Air Bag System" before
starting to work and observe every
precaution during work. Neglecting them
may result in personal injury or
undeployment of the air bag when
necessary.
Removal
1) Disable air bag system. Refer to "Disabling Air Bag
System".
2) Remove blower unit and fresh air inlet duct referring
to "Blower Unit Removal and Installation in Section
7A".
3) Disconnect passenger air bag (inflator) module
connector (1) as shown in the figure.
a) Unlock lock button (2).
b) With lock button unlocked, disconnect connector.
S3RH0A8206007
a)
2
b)
1
I3RH0A820066-01
4) Remove passenger air bag (inflator) module
attaching bolts (1) and screws (2).
5) Remove passenger air bag (inflator) module claw (1)
from instrument panel (2).
6) Remove passenger air bag (inflator) module from
vehicle.
WARNING
!
Special care is necessary when handling and
storing a live (undeployed) air bag (inflator)
module. Observe "Precautions on Handling
and Storage of Air Bag Components".
Otherwise, personal injury may result.
2
1
Installation
1) Install passenger air bag (inflator) module to
instrument panel.
CAUTION
!
Confirm claw (1) of passenger air bag
(inflator) module hangs in instrument panel
(2).
2
1
I3RH0A820067-01
1
I3RH0A820068-01