Suzuki Liana RH413 Service Manual page 426

3B-13 Differential:
Tooth contact pattern
Low contact
Pinion is positioned too close to the center of drive
bevel gear.
1. Decrease thickness of pinion height adjusting
shim and position pinion farther from gear
center.
2. Adjust drive bevel gear backlash to
I3RH01322044-01
specification.
If adjustment is impossible, replace differential
carrier.
I3RH01322045-01
• Drive bevel gear or drive bevel pinion defective.
• Poor squareness of differential carrier.
• Differential carrier surface where gear is installed
is defective.
Replace defective part as an assembly.
I3RH01322046-01
1. Check seating of bevel gear or differential case.
(Check bevel gear for runout).
2. If adjustment is impossible, replace drive bevel
gear and pinion as a set or differential carrier.
I3RH01322047-01
Replace drive bevel gear and pinion as a set or
differential case, if found defective.
I3RH01322048-01
Diagnosis and remedy