Suzuki Liana RH413 Service Manual page 646

5A-98 Automatic Transmission/Transaxle:
16) For 4WD model, remove transaxle housing lower
plate.
17) Holding drive plate with a flat head rod or the like (2)
against rotation, remove drive plate to torque
converter bolts (1).
2
18) For 4WD model, remove transfer referring to
"Transfer Dismounting and Remounting in Section
3C".
19) Using flat head rod or the like (2), pull out drive shaft
joints (1) at differential side so as to release snap
ring fitting.
For right side of 4WD model, using plastic hammer,
drive out drive shaft joint (1) so as to release snap
ring fitting of joint spline at intermediate shaft of
transfer (3).
1
I2RH0B510073-01
I2RH0B510074-01
20) Remove ball stud bolts and lock nuts from both
knuckles and detach suspension arms and then pull
out both drive shaft joints from differential.
21) For 2WD vehicle, remove engine rear mounting (1)
with its brackets (2).
22) Remove transaxle and engine fastening bolts and
nut.
23) Support transaxle with transmission jack.
24) Remove engine LH mounting (1) and its bracket (3).
2
2. Transaxle
WARNING
!
Be sure to keep transaxle with torque
converter horizontal or facing up through out
the work. Should it be tilted with torque
converter down, converter may fall off and
cause personal injury.
1
3
I2RH0B510075-01