Suzuki Liana RH413 Service Manual page 569

DTC No.
Type I Type II
— 12 No malfunction is detected
Transmission range sensor
circuit malfunction
P0705 34
36 Transmission fluid
P0710 temperature sensor circuit
38
malfunction
Input / Turbine speed
P0715 14 sensor circuit malfunction
Output speed sensor / VSS
P0720 31
circuit malfunction
Engine speed input circuit
malfunction
P0725 35
Torque converter clutch
circuit performance or
stuck off
*1 *1
P0741 29
Torque converter clutch
25 system electrical
P0743
26
Pressure control solenoid
41
electrical
P0748
42
Shift solenoid-A / No.1
performance or stuck off
*1 *1
P0751 17
Shift solenoid-A / No.1
21 electrical
P0753
22
Shift solenoid-B / No.2
performance or stuck off
*1 *1
P0756 28
Detecting item
• No sensor signal is inputted.
or
• Multiple signals are inputted
Sensor output voltage is too high
Sensor output voltage is too low
No sensor signal is detected although
output shaft speed sensor signal is
detected.
No sensor signal is inputted although input
shaft speed sensor signal is inputted.
No engine speed signal is inputted
although engine is running and engine
coolant temperature sensor signal is in
normal condition.
• Difference in revolution between engine
or
• Difference in revolution between engine
Voltage of TCC solenoid terminal is high
although TCM is commanding TCC
solenoid to turn OFF.
Voltage of TCC solenoid terminal is low
although TCM is commanding TCC
solenoid to turn ON.
No electric flow is detected on solenoid
circuit.
Too much electric flow is detected on
pressure control solenoid circuit.
• Actual gear position is 2nd gear
or
• Actual gear position is 3rd gear although
Voltage of shift solenoid terminal is high
although TCM is commanding shift
solenoid to turn OFF.
Voltage of shift solenoid terminal is low
although TCM is commanding shift
solenoid to turn ON.
• Actual gear position is 4th gear although
or
• Actual gear position is 3rd gear although
Automatic Transmission/Transaxle:
Detecting condition
(DTC will set when detecting:)
—
simultaneously.
and input shaft is too large although
TCM is commanding TCC solenoid to
turn ON.
and input shaft is too small although
TCM is commanding TCC solenoid to
turn OFF.
although TCM command is for 3rd gear.
TCM command is for 2nd gear.
TCM command is for 3rd gear.
TCM command is for 4th gear.
5A-21
A B
— —
*4 *3 *4
2 driving 2 driving
cycle cycle
*3
1 driving
1 driving
cycle
cycle
1 driving 1 driving
cycle cycle
1 driving 1 driving
cycle cycle
1 driving 1 driving
cycle cycle
2 driving Not
cycles applicable
*3
1 driving
1 driving
cycle
cycle
1 driving 1 driving
cycle cycle
2 driving Not
cycles applicable
1 driving 1 driving
cycle cycle
2 driving Not
cycles applicable