Abs Hydraulic Unit / Control Module Assembly On-Vehicle Inspection; Abs Hydraulic Unit / Control Module Assembly Removal And Installation - Suzuki Liana RH413 Service Manual

ABS Hydraulic Unit / Control Module Assembly
On-Vehicle Inspection
CAUTION
!
Never disassemble ABS hydraulic unit /
control module assembly, loosen blind plug
or remove motor. Performing any of these
prohibited services will affect original
performance of ABS hydraulic unit / control
module assembly.
Check hydraulic unit for fluid leakage.
If any, repair or replace.
ABS Hydraulic Unit / Control Module Assembly
Removal and Installation
CAUTION
!
Never disassemble ABS hydraulic unit /
control module assembly, loosen blind plug
or remove motor. Performing any of these
prohibited services will affect original
performance of ABS hydraulic unit / control
module assembly.
Removal
NOTE
Before removal, inspect the parts referring to
"ABS Hydraulic Unit / Control Module
Assembly On-Vehicle Inspection".
1) Disconnect negative cable from battery.
2) Disconnect ABS hydraulic unit / control module
assembly connector (1) by pull down the lock (2).
[A]
[A]: Disconnect
[B]: Connect
S3RH0A4506003
S3RH0A4506004
[B]
1
2
D
C
I4RH01450001-01
C: Pull down to disconnect
D: Pull up to connect
3) Using special tool, loosen flare nuts (1) and
disconnect brake pipes (2) from ABS hydraulic unit /
control module assembly (3).
Special tool
(A): 09950-78220
NOTE
Put bleeder plug cap or the like onto pipe to
prevent fluid from spilling. Do not allow brake
fluid to get on painted surfaces.
4) Remove three bolts and disconnect take out ABS
hydraulic unit / control module assembly (1) from
bracket using flat end rod or the like (2).
CAUTION
!
• Do not give an impact to hydraulic unit.
• Use care not to allow dust to enter
hydraulic unit.
• Do not place hydraulic unit on its side or
upside down. Handling it in inappropriate
way will affect its original performance.
ABS: 4E-35
I4RH01450016-01
I2RH01450046-01