Side Sensor Removal And Installation - Suzuki Liana RH413 Service Manual

Side Sensor Removal and Installation

WARNING
!
During service procedures, be very careful
when handling a sensor.
• Never strike or jar a sensor.
• Under some circumstance, it could cause
improper operation of the air bag system.
A sensor bolt must be carefully torqued to
assure proper operation.
Removal
1) Disconnect negative (–) cable at battery.
2) Disable air bag system. Refer to "Disabling Air Bag
System".
3) Remove center pillar lower trim and side sill scuff.
4) Turn up floor carpet at front seat side.
5) Remove side sensor bolt (1), and side sensor (2)
from under body (3).
3
6) Disconnect side sensor connector sliding connector
outer (1) as shown.
1
S3RH0A8206011
2
1
I3RH0A820061-01
1
I3RH0A820062-01
Installation
CAUTION
!
Proper operation of side sensor requires
sensor be rigidly attached to specified
position.
1) Check that none of following faulty conditions exists.
• Bend, deformity or rust of under body.
• Foreign matter on mating surface of sensor.
2) Install side sensor (1) on under body (2) and tighten
side sensor bolt (3) to specified torque.
Tightening torque
Side sensor bolt (a): 9 N·m (0.9 kgf-m, 6.5 lb-ft)
3, (a)
3) Connect side sensor connector pushing connector
inner (1) as shown.
1
1
4) Connect negative cable at battery.
5) Enable air bag system. Refer to "Enabling Air Bag
System".
Air Bag System: 8B-100
1
2
I3RH0A820063-01
I3RH0A820064-01