Suzuki Liana RH413 Service Manual page 690

5A-142 Automatic Transmission/Transaxle:
9) Install 1st and reverse brake return spring
subassembly (1) to transaxle case (2).
10) Apply A/T fluid to 1st and reverse brake discs (2)
separator plates (3) and retaining plate (1), then
install them to transaxle case.
11) Compress 1st and reverse brake return spring using
special tool and hydraulic press, then attach snap
ring.
CAUTION
!
Do not damage 1st and reverse brake return
spring subassembly discs, plates and piston
by pressing in 1st and reverse brake return
spring subassembly passing through its
original installing position over 0.8 mm (0.031
in.).
Special tool
(A): 09926–97620
12) Install 1st and reverse brake plate snap ring so that
its both ends would be positioned in correct locations
as shown in the figure.
I2RH0B510265-01
13) Using special tools, measure 1st and reverse brake
piston stroke when compressed air (400 – 800 kPa,
I2RH0B510266-01
4 – 8 kg/cm
Special tool
(A): 09900–20607
(B): 09900–20701
(C): 09952–06020
1st and reverse brake piston stroke
Standard: 0.791 – 1.489 mm (0.0311 – 0.0586 in.)
14) Install reduction drive gear (1) to transaxle case (3)
by using special tools and hydraulic press.
CAUTION
!
• Do not use transaxle case as groundwork
to press fit reduction drive gear.
I2RH0B510267-01
• Do not give load more than 20 kN (2000 kg,
4410 lb) with hydraulic press. Otherwise, it
may result in damaging reduction drive
gear bearing.
[A]: Correct
[B]: Incorrect
2 , 57 – 113 psi) is brown through oil hole.
I2RH0B510268-01
I2RH0B510269-01