Suzuki Liana RH413 Service Manual page 1035

v) Clear space (5) on ground about 185 cm (6
ft) in diameter where seat belt pretensioner
(2) is to be activated. Paved, outdoor
location where there is no activity is
preferred. If outdoor location is not available,
space on shop floor where there is no activity
and provide sufficient ventilation. Ensure no
loose or flammable objects are within
activation area.
vi) Place wheel-installed tire (4) with seat belt
pretensioner (2) on ground in step v).
10 cm
(3.9 in.)
3
7) Stretch deployment harness (A) from air bag
(inflator) module or seat belt pretensioner to its full
length 10 m (33 ft).
Special tool
(A): 09932-75030
8) Place 12 volts vehicle battery (1) near shorted end of
deployment harness (A).
9) Verify that area around air bag (inflator) module or
seat belt pretensioner is clear of all people and loose
or flammable objects.
1
5
2
3
4
I3RH0A820088-01
10) Connect adapter cable (B) or (C) as follows.
Special tool
(B): 09932-78332
a) For driver air bag (inflator) module
Verify that driver air bag (inflator) module is
resting with its vinyl trim cover facing up, and
connect adapter cable (B) to driver air bag
(inflator) module.
b) For passenger air bag (inflator) module
Verify that passenger air bag (inflator) module is
firmly and properly secured on deployment
fixture (special tool), and connect adapter cable
(B) to passenger air bag (inflator) module.
c) For side air bag (inflator) module
Verify that side air bag (inflator) module is firmly
and properly secured on deployment fixture
(special tool), and connect adapter cable (B) to
side air bag (inflator) module.
d) For seat belt pretensioner:
i) Connect adapter cable (C) to seat belt
pretensioner.
ii) Pile 2 wheel-installed tires (2) on top of tire
with seat belt pretensioner (3), and tie them
with wire harness (4) as shown.
Wire harness specification
Stripped wire harness section 1.25 mm
(0.0019 in. 2 ) or more (Stripped wire
harness diameter 1.25 mm (0.05 in.) or
more)
NOTE
Wind wire harness around at least 2 times.
iii) Drape blanket (5) over those tires.
11) Connect adapter cable (B) or (C) to deployment
harness (A) connector and lock connectors with lock
slider.
Air Bag System: 8B-110
2