Solenoid Valves (Shift Solenoid Valves, Tcc Solenoid Valve And Timing Solenoid Valve) Inspection - Suzuki Liana RH413 Service Manual

5A-88 Automatic Transmission/Transaxle:
3) Install transmission fluid sensor (5) and sensor wire
to clamp.
4) Install oil strainer assembly (1).
Tightening torque
Oil strainer bolt (a): 10 N·m (1.0 kgf-m, 7.5 lb-ft)
5) Install new oil pan gasket (1) and oil pan (2).
Tightening torque
Oil pan bolt (b): 7.0 N·m (0.7 kgf-m, 5.0 lb-ft)
Solenoid Valves (Shift Solenoid Valves, TCC
Solenoid Valve and Timing Solenoid Valve)
Inspection
Resistance Check
Check shift solenoid valves, timing solenoid valve and
TCC solenoid valve resistance.
Shift solenoid valves, timing solenoid valve and TCC
solenoid valve resistance
Standard: 11 – 15 Ω at 20 °C (68 °F)
I2RH0B510058-01
Operation Check
Shift solenoid valve-A (No.1), -B (No.2) and TCC
solenoid valve
CAUTION
!
Do not insert air gun against strainer
I2RH0B510059-01
installed on inlet of solenoid valve too deeply,
when blowing air into solenoid valve. If not,
the strainer will be damaged.
• Check that solenoid valve (1) actuate with click sound
when battery voltage is conducted.
• When solenoid valve (1) is connected to battery (2),
confirm that solenoid valve is close condition by
blowing air (50 – 200 kpa, 0.5 – 2.0 kg/cm
psi) into solenoid valve as shown in the figure.
I2RH0B510060-01
S3RH0A5106016
I2RH0B510061-01
2 , 7 – 28.5