Transfer Right Case And Left Case Disassembly And Assembly - Suzuki Liana RH413 Service Manual

Transfer Right Case and Left Case Disassembly
and Assembly
Disassembly
1) Remove oil seals (1) from transfer right case and left
case by using special tool.
Special tool
(A): 09913–50121
2) Remove oil protect plate (2) and oil receiver (3) from
transfer right case.
(A)
1
3) Remove adjuster plates (1) from transfer right and
left cases.
4) Remove bevel gear adjuster (2) from transfer right
and left cases by using special tool.
Special tool
(A): 09940–14940
1
(A)
2
Assembly
1) Apply grease to reduction drive gear oil seal lips.
"A": Grease 99000–25010
2) Install reduction drive gear oil seals (1, 2) to right
case (3) by using special tool.
CAUTION
!
Use care the installation direction and depth
of oil seals for correct installation.
S3RH0A3306006
3
2
I3RH01332015-01
I3RH01332016-01
Special tool
: 09913–75520
Transfer reduction drive gear oil seal installing
depth
"a": 13.3 – 14.3 mm (0.524 – 0.563 in.)
"b": 2.8 – 3.8 mm (0.110 – 0.150 in.)
3) Fill inside of oil seal (2) with grease of about 3 g
(0.11 oz.).
"A": Grease 99000–25010
4) Screw bevel gear adjuster (1) in right case (2) until
side face of bevel gear adjuster (1) come to flush
position with side face of right case (2) by using
special tool.
Special tool
(A): 09940–14940
NOTE
Do not screw in bevel gear adjuster
excessively, or preload of reduction idler
gear taper roller bearing may not be adjusted
accurately.
(A)
1
2
Transfer: 3C-10
I3RH0A330005-01
I3RH01332031-01