Suzuki Liana RH413 Service Manual page 445

4) Drive out bevel pinion shaft (1) from transfer output
retainer by tapping it with plastic hammer (2).
2
1
5) Drive out pinion shaft bearing from bevel pinion shaft
by using bearing puller and hydraulic press.
6) Remove pinion shaft oil seal (1) by using special
tool.
Special tool
(A): 09913–50121
1
7) Remove pinion shaft rear taper roller bearing (1) and
spacer (2).
2
1
8) Drive out pinion shaft taper roller bearing outer races
(2) (front and rear) by using brass bar (1).
Assembly
1) To mesh bevel gears correctly, it is prerequired to
I3RH01332019-01
(A)
I3RH01332020-01
I3RH01332021-01
I3RH01332022-01
CAUTION
!
• Bevel gear and pinion must be replaced as
a set when either replacement becomes
necessary.
• When replacing taper roller bearing,
replace as inner race & outer race
assembly.
install bevel pinion to transfer output retainer
properly by using adjusting shim (bevel pinion shim)
as follows.
a) Install pinion shaft front taper roller bearing (1) to
bevel pinion dummy (special tools).
Special tool
(A): 09922–76140
(B): 09922–76420
b) Install bevel pinion dummy (1), pinion shaft rear
taper roller bearing (2) and special tools to
transfer output retainer (3).
Special tool
(A): 09922–76140
(B): 09922–76420
(C): 09922–76310
(D): 09922–76320
(E): 09922–76340
(F): 09922–76150
NOTE
This installation requires no spacer or oil
seal.
Transfer: 3C-12
I3RH01332053-01