Switchport Access Vlan - Cisco Catalyst 3650 Command Reference Manual

switchport access vlan

switchport access vlan

To configure a port as a static-access port, use the switchport access vlan command in interface configuration
mode. To reset the access mode to the default VLAN mode for the switch, use the no form of this command.
switchport access vlan vlan-id
no switchport access vlan
Syntax Description
vlan-id
Command Default
The default access VLAN and trunk interface native VLAN is a default VLAN corresponding to the platform
or interface hardware.
Command Modes
Interface configuration
Command History
Release
Cisco IOS XE 3.3SE
Usage Guidelines
The port must be in access mode before the switchport access vlan command can take effect.
If the switchport mode is set to access vlan vlan-id, the port operates as a member of the specified VLAN.
An access port can be assigned to only one VLAN.
The no switchport access command resets the access mode VLAN to the appropriate default VLAN for the
device.
Examples This example shows how to change a switched port interface that is operating in access mode to operate in
VLAN 2 instead of the default VLAN:
Switch(config-if)# switchport access vlan 2
Related Commands
Command
switchport mode
Layer 2/3 Command Reference, Cisco IOS XE Release 3.6E (Catalyst 3650 Switch)
74
VLAN ID of the access mode VLAN; the range is 1 to 4094.
Description
Configures the VLAN membership mode of a port.
Layer 2/3 Commands
Modification
This command was introduced.
OL-32639-01