Configuring Switch Wide Settings; Configuring Vlan Settings - Cisco C9200L-24T-4X-A Hardware Installation Manual

Configuring Switch Wide Settings

Setting
Mitigate Address Spoofing
Service Timestamp
Management Interface
QoS Policy
Uplink Interfaces
Downlink Interfaces
Cross-connect Interfaces
Figure 45: Site Profile - Core Switches
Configuring Switch Wide Settings

Configuring VLAN Settings

Procedure
Step 1
In the VLAN Configuration section, you can configure both data and voice VLANs. Type a name for your
data VLAN.
Cisco Catalyst 9200 Series Switches Hardware Installation Guide
64
Standalone Core Switch (with
ECMP Peers)
Unicast RPF (uRPF) in strict mode
Enabled
Layer 3 settings configured on the
management port, based on Quick
Setup
QoS Policy for Distribution/Core
defined
Selected uplink ports connect to
MAN/WAN device
Downlink connections to access
switches
Selected ports connect to other core
switches
Configuring the Switch
Standalone Collapsed Core Switch
(with ECMP Peer and Port Channel
Downlink)
Unicast RPF (uRPF) in strict mode
Enabled
Layer 3 settings configured on the
management port, based on Quick
Setup
QoS Policy for Distribution/Core
defined
Selected uplink ports connect to
MAN/WAN device
Downlink connections to
distribution switches
Selected ports connect to other core
switches