Tunnel Commands; Interface Tunnel 1; Tunnel Isatap Solicitation-Interval - Cisco 300 Series Cli Manual

Tunnel Commands

Tunnel Commands
78-21075-01 Command Line Interface Reference Guide
45.1 interface tunnel
Use the interface tunnel Global Configuration mode command to enter the
Interface Configuration (Tunnel) mode.
Syntax
number
interface tunnel
Parameters
number— Specifies the tunnel number.
Default Configuration
N/A
Command Mode
Global Configuration mode
Example
The following example enters the Interface Configuration (Tunnel) mode.

interface tunnel 1

tunnel source auto
exit
45.2

tunnel isatap solicitation-interval

Use the tunnel isatap solicitation-interval Global Configuration mode command to
set the time interval between unsolicited router solicitation messages. Use the no
form of this command to restore the default configuration.
Syntax
tunnel isatap solicitation-interval
no tunnel isatap solicitation-interval
seconds
45
751