Ipv6 Tunnel Commands; Interface Tunnel - Cisco Sx350 Cli Manual

IPv6 Tunnel Commands

Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
33.0

33.1 interface tunnel

To enter into the Interface Configuration (Tunnel) mode, use the interface tunnel
command in Global Configuration mode.
Syntax
number
interface tunnel
Parameters
•
number
—Specifies the tunnel number.
Default Configuration
N/A
Command Mode
Global Configuration mode
Example
The following example enters the Interface Configuration (Tunnel) mode.
switchxxxxxx(config)#
switchxxxxxx(config-if)#
switchxxxxxx(config-if)#
interface tunnel 1
tunnel source auto
exit
33
742