Snmp-Server Trap Authentication; Snmp-Server Contact - Cisco 300 Series Cli Manual

Small business 300 series managed switches command line interface guide release 1.3
Hide thumbs Also See for 300 Series:
Table of Contents

Advertisement

12
218

12.17 snmp-server trap authentication

Use the snmp-server trap authentication Global Configuration mode command to
enable the device to send SNMP traps when authentication fails. Use the no form
of this command to disable SNMP failed authentication traps.
Syntax
snmp-server trap authentication
no snmp-server trap authentication
Parameters
N/A
Default Configuration
SNMP failed authentication traps are enabled.
Command Mode
Global Configuration mode
User Guidelines
The command
snmp-server enable traps
Therefore, if that command is enabled (it is enabled by default), this command is
not necessary.
Example
The following example disables all SNMP traps and enables only failed
authentication traps.
switchxxxxxx(config)#
switchxxxxxx(config)#

12.18 snmp-server contact

Use the snmp-server contact Global Configuration mode command to set the
value of the system contact (sysContact) string. Use the no form of the command
to remove the system contact information.
Network Management Protocol (SNMP) Commands
enables all traps including failure traps.
no snmp-server enable traps
snmp-server trap authentication
78-21075-01 Command Line Interface Reference Guide

Advertisement

Table of Contents
loading

Table of Contents