Snmp-Server Group - Cisco 300 Series Cli Manual

Network Management Protocol (SNMP) Commands
OL-32830-01 Command Line Interface Reference Guide

45.7 snmp-server group

To configure an SNMP group, use the snmp-server group Global Configuration
mode command. Groups are used to map SNMP users to SNMP views. To remove
an SNMP group, use the no form of this command.
Syntax
groupname
snmp-server group
[read readview] [write writeview]
no snmp-server group
Parameters
•
groupname
group
•
v1—Specifies the SNMP Version 1 security model.
•
v2—Specifies the SNMP Version 2 security model.
•
v3—Specifies the SNMP Version 3 security model.
•
noauth—Specifies that no packet authentication will be performed.
Applicable only to the SNMP version 3 security model.
•
auth—Specifies that packet authentication without encryption will be
performed. Applicable only to the SNMP version 3 security model.
•
priv—Specifies that packet authentication with encryption will be
performed. Applicable only to the SNMP version 3 security model. Note that
creation of SNMPv3 users with both authentication and privacy must be
done in the GUI. All other users may be created in the CLI.
•
notifyview
notify
generating informs or a traps. An inform is a trap that requires
acknowledgement. Applicable only to the SNMP version 3 security model.
(Length: 1–30 characters)
•
readview
read
only. (Length: 1–30 characters)
•
writeview
write
configuring the agent. (Length: 1–30 characters)
Default Configuration
No group entry exists.
v1 | v2 | v3 {noauth | auth | priv} [notify notifyview]}
{
groupname {v1 | v2 | v3 [noauth | auth | priv]}
—Specifies the group name. (Length: 1–30 characters)
—(Optional) Specifies the view name that enables
—(Optional) Specifies the view name that enables viewing
—(Optional) Specifies the view name that enables
45
866