Enabling Rrpp; Optional) Setting The Values Of Rrpp Domain Timers - Huawei Quidway S3700 Series Configuration Manual

Quidway S3700 Series Ethernet Switches
Configuration Guide - Reliability
system-view
The system view is displayed.
Step 2 Run:
rrpp domain domain-id
The domain view is displayed.
Step 3 Run:
ring ring-id enable
The RRPP ring is enabled.
----End

3.3.9 Enabling RRPP

To activate an RRPP ring, you must enable RRPP and the RRPP ring.
Context
Do as follows on all switches in the RRPP domain:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
rrpp enable
The RRPP protocol is enabled.
----End

3.3.10 (Optional) Setting the Values of RRPP Domain Timers

Two timers, that is, the Hello timer and the Fail timer are used when master nodes are sending
and receiving RRPP protocol packets. The Hello timer is used when primary ports are sending
Hello packets. The Fail timer is used when secondary ports are receiving the Hello packets sent
by the local node.
Context
Do as follows on the master node in the RRPP domain:
Procedure
Step 1 Run:
system-view
Issue 01 (2011-10-26)
NOTE
The RRPP ring can be activated only when both the RRPP ring and RRPP protocol are enabled.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 RRPP Configuration
59