Peer-Link Port-Channel - Dell S6100 Configuration Manual

Version
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.5(0.1)
9.2(0.0)
9.2(0.2)
9.0.2.0

peer-link port-channel

Configure the specified port channel as the chassis interconnect trunk between VLT peers in the domain.
Syntax peer-link port-channel port-channel-number {peer-down-vlan vlan id}
Parameters
port-channel-
number
peer-down-vlan
vlan id
Defaults Not configured.
Command Modes VLT DOMAIN
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.5(0.1)
9.2(0.0)
9.0.2.0
9.0.0.0
8.3.19.0
8.3.12.0
8.3.8.0
Description
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the M I/O Aggregator. This command is supported in Programmable-Mux
(PMUX) mode only.
Introduced on the Z9000, S4810, and S4820T.
Introduced on the S6000.
Enter the port-channel number that acts as the interconnect trunk.
Enter the keywords peer-down-vlan then a VLAN ID to configure the VLAN that the
VLT peer link uses when the VLT peer is down.
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the M I/O Aggregator. This command is supported in Programmable-Mux
(PMUX) mode only.
Introduced on the S6000.
Introduced on the Z9000.
Introduced on the S4820T.
Added support for the peer-down-vlan option.
Introduced on the S4810.
Virtual Link Trunking (VLT) 1675