19.8.2 SNMP Traps
The ZyXEL Device will send traps to the SNMP manager when any one of the following
events occurs:
Table 108 SNMP Traps
TRAP #
TRAP NAME
0
coldStart (defined in RFC-1215)
1
warmStart (defined in RFC-1215)
4
authenticationFailure (defined in
RFC-1215)
6
whyReboot (defined in ZYXEL-
MIB)
6a
For intentional reboot:
6b
For fatal error:
19.8.3 Configuring SNMP
To change your ZyXEL Device's SNMP settings, click Advanced > Remote MGMT >
SNMP. The screen appears as shown.
Figure 159 Remote Management: SNMP
P-2802H(W)(L)-I Series User's Guide
Chapter 19 Remote Management Configuration
DESCRIPTION
A trap is sent after booting (power on).
A trap is sent after booting (software reboot).
A trap is sent to the manager when receiving any
SNMP get or set requirements with the wrong
community (password).
A trap is sent with the reason of restart before
rebooting when the system is going to restart (warm
start).
A trap is sent with the message "System reboot by
user!" if reboot is done intentionally, (for example,
download new files, CI command "sys reboot", etc.).
A trap is sent with the message of the fatal code if the
system reboots because of fatal errors.
267