Table of Contents
Advertisement
8) While depressing the brake pedal, tighten a new
axle nut (olive color) to the specified torque and
lock it securely.
Tightening torque:
⋅
220 N
m (22.4 kgf-m, 162 ft-lb)
CAUTION:
• Install the wheel after installation of the axle
nut. Failure to follow this rule may damage the
wheel bearing.
• Be sure to tighten axle nut to specified
torque. Do not overtighten it as this may dam-
age wheel bearing.
9) After tightening axle nut, lock it securely.
10) Add transmission gear oil. (MT model)
11) Add differential gear oil. (AT model)
C: DISASSEMBLY
1) Place alignment marks on the shaft and outer
race.
2) Remove the PTJ boot band and boot.
CAUTION:
Be careful not to damage boot.
Front Drive Shaft
3) Remove the snap ring from PTJ outer race.
4) Remove the PTJ outer race from shaft assem-
bly.
5) Wipe off grease.
CAUTION:
The grease is a special grease. Do not confuse
with other greases.
6) Place alignment marks on the roller kit and trun-
nion.
DS-00106
7) Remove the roller kit from trunnion.
DS-00107
CAUTION:
Be careful with the roller kit position.
DS-23
DRIVE SHAFT SYSTEM
DS-00108
DS-00109
Advertisement
Chapters
Table of Contents
