Example For Configuring The Tftp Client - Huawei Quidway S2700 Series Configuration Manual

Quidway S2700 Series Ethernet Switches
Configuration Guide - Basic Configuration
return

8.7.4 Example for Configuring the TFTP Client

In this example, the TFTP application is run on the TFTP server and the location of the source
file on the server is set. After that, you can upload and download files.
Networking Requirements
As shown in
10.1.1.2 functions as the TFTP server.
The Switch acts as a TFTP client. VLAN 10 is created on the Switch, and Ethernet0/0/1 is added
to VLAN 10. The IP address 10.1.1.1/24 is assigned to VLANIF 10.
The Switch downloads files from the TFTP server.
Figure 8-4 Networking diagram for configuring TFTP
PC
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
Procedure
Step 1 Enable TFTP on the remote server to ensure that the TFTP application software is started.
Step 2 Create VLAN 10 on the Switch and assign the IP address 10.1.1.1/24 to VLANIF 10.
<Quidway> system-view
[Quidway] vlan 10
[Quidway-vlan10] quit
[Quidway] interface ethernet 0/0/1
[Quidway-Ethernet0/0/1] port hybrid pvid vlan 10
[Quidway-Ethernet0/0/1] port hybrid untagged vlan 10
Issue 01 (2011-07-15)
Figure 8-4, the Switch cannot function as the TFTP server. The remote server at
TFTP session
configuration
cable
TFTP Client
Run the TFTP software on the TFTP server and set the position where the source file is
located on the Switch.
Download files through TFTP commands on the Switch.
TFTP software installed on the TFTP server
Path of the source file on the TFTP server
Name of the destination file and position where the destination file is located on the Switch
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
TFTP Server
8 FTP and TFTP
114