Example For Outputting Alarms To The Snmp Agent; Figure 2-8 Networking Diagram Of Outputting Alarms To The Snmp Agent - Huawei Quidway S9300 Configuration Manual

2 Information Center Configuration
IO Reg messages = 123 IO Sent messages = 282
----End
Configuration Files
#
sysname Quidway
#
vlan 10
#
interface Vlanif10
ip address 10.1.1.1 255.255.255.0
#
interface GigabitEthernet1/0/1
port hybrid pvid vlan 10
port hybrid untagged vlan 10
#
info-center filter-id 1077514264
info-center source FIB channel 0 log level alert
info-center loghost 11.1.1.6 binary
#
return

2.6.5 Example for Outputting Alarms to the SNMP Agent

Networking Requirements
As shown in
transmitted to the NMS through SNMP.

Figure 2-8 Networking diagram of outputting alarms to the SNMP Agent

NM Station
10.1.1.1/24
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
Data Preparation
To complete the configuration, you need the following data:
l
2-44
Figure 2-8, alarms are required to be output first to the SNMP agent and then be
GE1/0/1
Enable the information center on the switch.
Specify the module enabled to output logs and configure the channel through which the
alarm is output.
Enable outputting alarm to the SNMP agent.
Enable transmitting alarms to the NMS through SNMP.
Information channel number
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Device Management
Agent
10.1.1.2/24
Issue 01 (2010-12-15)