Gvrp Registration - H3C S3100 Series Command Manual

Command Manual (For Soliton) – GVRP
H3C S3100 Series Ethernet Switches
# Enable GVRP on Ethernet 1/0/1.
[Sysname] interface Ethernet 1/0/1
[Sysname-Ethernet1/0/1] gvrp
GVRP is enabled on port Ethernet1/0/5.

1.2.4 gvrp registration

Syntax
gvrp registration { fixed | forbidden | normal }
undo gvrp registration
View
Ethernet port view
Parameters
fixed: Specifies the fixed GVRP registration mode. A port operating in this mode cannot
register or deregister VLAN information dynamically. It only propagates static VLAN
information. Besides, the port permits only static VLANs, that is, it propagates only
static VLAN information to the other GARP members.
forbidden: Specifies the forbidden GVRP registration mode. A port operating in this
mode cannot register or deregister VLAN information dynamically. It permits only VLAN
1, that is, it propagates only the information about VLAN 1 to the other GARP members.
normal: Specifies the normal mode. A port operating in this mode can dynamically
register or deregister VLAN information and can propagate both dynamic and static
VLAN information.
Description
Use the gvrp registration command to configure the GVRP registration mode on a
port.
Use the undo gvrp registration command to restore the default GVRP registration
mode on a port.
By default, the GVRP registration mode is normal.
Note that these commands only apply to trunk ports.
Related commands: display gvrp statistics
Examples
# Configure Ethernet1/0/1 to operate in fixed GVRP registration mode.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface Ethernet1/0/1
Chapter 1 GVRP Configuration Commands
1-9