H3C S3100 Series Command Manual page 923

Command Manual (For Soliton) – System Maintenance and Debugging
H3C S3100 Series Ethernet Switches
Receive optical power fault
PMA/PMD receiver local fault
PCS receive local fault
PHY XS receive local fault
RX power high
RX power low
Laser bias current fault
Laser temperature fault
Laser output power fault
TX fault
PMA/PMD receiver local fault
PCS receive local fault
PHY XS receive local fault
TX bias high
TX bias low
TX power high
TX power low
Temp high
Temp low
Transceiver info I/O error
Transceiver info checksum error
Transceiver type and port
configuration mismatch
Transceiver type not supported by
port hardware
Note:
For pluggable transceivers supported by S3100 series Ethernet switches, refer to H3C
S3100 Series Ethernet Switches Installation Manual(For Soliton).
Field
3-9
Chapter 3 Device Management
Remarks
Receive optical power fault
PMA/PMD (Physical Medium
Attachment/Physical Medium Dependent)
receiver local fault
PCS (Physical Coding Sublayer) receiver local
fault
PHY XS (PHY Extended Sublayer) receive
local fault
RX power is high.
RX power is low.
Laser bias current fault
Laser temperature fault
Laser output power fault
TX fault
PMA/PMD receiver local fault
PCS receive local fault
PHY XS receive local fault
TX bias current is high.
TX bias current is low.
TX power is high.
TX power is low.
Temperature is high.
Temperature is low.
Transceiver information read and write error
Transceiver information checksum error
Transceiver type does not match port
configuration.
Transceiver type is not supported on the port.
Commands