Igmp-Snooping General-Query Source-Ip - H3C S3100 Series Command Manual

Command Manual (For Soliton) – Multicast
H3C S3100 Series Ethernet Switches

1.1.6 igmp-snooping general-query source-ip

Syntax
igmp-snooping general-query source-ip { current-interface | ip-address }
undo igmp-snooping general-query source-ip
View
VLAN view
Parameters
current-interface: Specifies the IP address of the current VLAN interface as the source
address of IGMP general queries. If the current VLAN interface does not have an IP
address, the default IP address 0.0.0.0 will be used as the source IP address of IGMP
general queries.
ip-address: Specifies the source address of IGMP general queries, which can be any
legal IP address.
Description
Use the igmp-snooping general-query source-ip command to configure the source
address of IGMP general queries.
Use the undo igmp-snooping general-query source-ip command to restore the
default.
This command can take effect only if the IGMP Snooping querier function is enabled on
the switch.
By default, the Layer 2 multicast switch sends general query messages with the source
IP address of 0.0.0.0.
Related commands: igmp-snooping querier, igmp-snooping query-interval.
Examples
# Configure the switch to send general query messages with the source IP address
2.2.2.2 in VLAN 3.
<Sysname> system-view
System view, return to user view with Ctrl+Z.
[Sysname] igmp-snooping enable
[Sysname] vlan 3
[Sysname-vlan3] igmp-snooping enable
[Sysname-vlan3] igmp-snooping querier
[Sysname-vlan3] igmp-snooping general-query source-ip 2.2.2.2
Chapter 1 IGMP Snooping Configuration
1-7
Commands