H3C S3100 Series Command Manual page 437

Command Manual (For Soliton) – AAA
H3C S3100 Series Ethernet Switches
Description
Use the display radius scheme command to display configuration information about
one specific or all RADIUS schemes
Related commands: radius scheme.
Examples
# Display configuration information about all RADIUS schemes.
<Sysname> display radius scheme
------------------------------------------------------------------
SchemeName
Primary Auth IP
Primary Acct IP
Second
Second
Auth Server Encryption Key= Not configured
Acct Server Encryption Key= Not configured
Accounting method = required
Accounting-On packet enable, send times = 15 , interval = 3s
TimeOutValue(in second)=3 RetryTimes=3 RealtimeACCT(in minute)=12
Permitted send realtime PKT failed counts
Retry sending times of noresponse acct-stop-PKT =500
Quiet-interval(min)
Username format
Data flow unit
Packet unit
calling_station_id format
unit 1 :
Primary Auth State=active,
Primary Acc
------------------------------------------------------------------
Total 1 RADIUS scheme(s). 1 listed
Table 1-5 Description on the fields of the display radius scheme command
SchemeName
Index
Type
=system
=127.0.0.1
=127.0.0.1
Auth IP =0.0.0.0
Acct IP =0.0.0.0
State=active,
Field
Chapter 1 AAA Configuration Commands
Index=0
Port=1645
Port=1646
Port=1812
Port=1813
=XXXX-XXXX-XXXX in lowercase
Second Auth State=block
Second Acc State=block
Description
Name of the RADIUS scheme
Index number of the RADIUS scheme
Type of the RADIUS servers
1-37
Type=extended
=5
=5
=without-domain
=Byte
=1