Display Diagnostic-Information - H3C S3100 Series Command Manual

Command Manual (For Soliton) – System Maintenance and Debugging
H3C S3100 Series Ethernet Switches
For information about the terminal monitor command, refer to Information Center
Command.
Example
# Enable IP packet debugging of the IP module.
<Sysname> debugging ip packet
<Sysname> display debugging
IP packet debugging is on

1.3.2 display diagnostic-information

Syntax
display diagnostic-information
View
Any view
Parameter
None
Description
Use the display diagnostic-information command to display system diagnostic
information, or save system diagnostic information to a file with the extension .diag in
the Flash memory.
Example
# Save system diagnostic information to the file default.diag.
<Sysname> display diagnostic-information
This operation may take a few minutes, continue?[Y/N]y
Diagnostic-information
N=display)?[Y/N]y
Please input the file name(*.diag)[flash:/default.diag]:
The file is already existing, overwrite it? [Y/N]y
% Output information to file: flash:/default.diag.
Please wait......
# Display the diagnostic information of the system.
<Sysname> display diagnostic-information
This operation may take a few minutes, continue?[Y/N]y
is saved to
1-10
Chapter 1 Basic System
Configuration and Debugging
Flash or displayed(Y=save
Commands