Display Transceiver Diagnosis Interface - H3C S3100 Series Command Manual

Command Manual (For Soliton) – System Maintenance and Debugging
H3C S3100 Series Ethernet Switches
Examples
# Display the alarm information of the transceiver on interface GigabitEthernet 1/1/2.
<Sysname> display transceiver alarm interface gigabitethernet 1/1/2
GigabitEthernet1/1/2 transceiver current alarm information:
TX fault
Table 3-6 Description on the fields of display transceiver alarm interface
transceiver current alarm information
TX fault

3.1.10 display transceiver diagnosis interface

Syntax
display transceiver diagnosis interface [ interface-type interface-number ]
View
Any view
Parameters
interface-type interface-number: Interface type and interface number.
Description
Use the display transceiver diagnosis interface command to display the currently
measured value of digital diagnosis parameters of a single or all anti-spoofing
transceivers customized by H3C.
Examples
# Display the currently measured value of digital diagnosis parameters of the
anti-spoofing pluggable optical transceiver customized by H3C on interface
GigabitEthernet 1/2/2.
<Sysname> display transceiver diagnosis interface gigabitethernet 1/2/2
GigabitEthernet1/2/2 transceiver diagnostic information:
Current diagnostic parameters:
Temp(°C)
35
Field
Voltage(V) Bias(mA)
3.26 6.18
3-10
Chapter 3 Device Management
Description
Current alarm information of the
transceiver
TX fault
RX power(dBM) TX power(dBM)
-35.64 -5.17
Commands