H3C S3100 Series Command Manual page 677

Command Manual (For Soliton) – Stack-Cluster
H3C S3100 Series Ethernet Switches
of the shared FTP server configured on the management device takes effect on the
management device only and will not be applied to the member devices through the
cluster management packets.
After the IP address of the shared FTP server is configured, network address
translation (NAT) is enabled on the management device immediately. When a member
device uses the ftp cluster command to access the shared FTP server, the
management device will translate the private IP address of the member device to a
public network address, forward the requests of the member device to the FTP server,
and forward the responses of FTP server to the member device according to the NAT
record.
Examples
# Configure FTP server 1.0.0.9 on the management device of a cluster.
<aaa_0.Sysname> system-view
System View: return to User View with Ctrl+Z.
[aaa_0.Sysname] cluster
[aaa_0.Sysname-cluster] ftp-server 1.0.0.9
2.3.16 holdtime
Syntax
holdtime seconds
undo holdtime
View
Cluster view
Parameters
seconds: Neighbor information holdtime in seconds, ranging from 1 to 255.
Description
Use the holdtime command to configure the neighbor information holdtime of the
member switches.
Use the undo holdtime command to restore the default holdtime value.
By default, the neighbor information holdtime is 60 seconds.
Note that:
If the management switch does not receive NDP information from a member
device within the holdtime, it sets the state of the member device to "down". When
the management device receives the NDP information from the device again, the
device will be re-added to the cluster automatically.
Chapter 2 HGMP V2 Configuration
2-35
Commands