H3C S3100 Series Command Manual page 196

Command Manual (For Soliton) – Port Basic Configuration
H3C S3100 Series Ethernet Switches
Parameter
across: Sets the MDI mode to medium dependent interface (MDI).
normal: Sets the MDI mode to media dependent interface-X mode (MDI-X).
auto: Sets the MDI mode to auto-sensing. Port operating in this mode adjust its MDI
mode between MDI and MDI-X automatically.
Note:
An RJ-45 interface can operate in MDI or MDI-X mode.
To connect two RJ-45 interfaces operating in the same MDI mode, use a crossover
cable; to connect two RJ-45 interfaces operating in different MDI modes, use a
straight-through cable.
Description
Use the mdi command to set the MDI mode for a port.
Use the undo mdi command to restore the default setting.
By default, a port operates in auto-sensing MDI mode.
Example
# Set the MDI mode of Ethernet 1/0/1 to MDI.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface Ethernet1/0/1
[Sysname-Ethernet1/0/1] mdi across
1.1.26 multicast-suppression
Syntax
multicast-suppression bps max-bps
undo multicast-suppression
View
Ethernet port view
Parameter
max-bps: Maximum number (in Kbps) of unknown multicast and unknown unicast
traffic that can be received per second on an Ethernet port (in step of 64).
For a 100Mbps Ethernet port, the max-bps argument is in the range 64 to 99,968.
Chapter 1 Port Basic Configuration
1-31
Commands